V4L/DVB (5466): Fix up some Cafe CCIC delay issues From: Jonathan Corbet Fix up unsociable Cafe CCIC delays. The Cafe CCIC driver contains some lengthy delays, some of which are unnecessary and some of which are done under lock. Some were marked with comments, but the comments somehow failed to make the issue go away. So fix it for real. Signed-off-by: Jonathan Corbet Signed-off-by: Mauro Carvalho Chehab --- drivers/media/video/cafe_ccic.c | 19 +++++++++++++------ 1 files changed, 13 insertions(+), 6 deletions(-) diff --git a/drivers/media/video/cafe_ccic.c b/drivers/media/video/cafe_ccic.c index f629c55..bfae5d2 100644 --- a/drivers/media/video/cafe_ccic.c +++ b/drivers/media/video/cafe_ccic.c @@ -705,7 +705,13 @@ static void cafe_ctlr_init(struct cafe_c cafe_reg_write(cam, REG_GL_CSR, GCSR_SRS|GCSR_MRS); /* Needed? */ cafe_reg_write(cam, REG_GL_CSR, GCSR_SRC|GCSR_MRC); cafe_reg_write(cam, REG_GL_CSR, GCSR_SRC|GCSR_MRS); + /* + * Here we must wait a bit for the controller to come around. + */ + spin_unlock_irqrestore(&cam->dev_lock, flags); mdelay(5); /* FIXME revisit this */ + spin_lock_irqsave(&cam->dev_lock, flags); + cafe_reg_write(cam, REG_GL_CSR, GCSR_CCIC_EN|GCSR_SRC|GCSR_MRC); cafe_reg_set_bit(cam, REG_GL_IMASK, GIMSK_CCIC_EN); /* @@ -773,9 +779,9 @@ static void cafe_ctlr_power_up(struct ca * Control 1 is power down, set to 0 to operate. */ cafe_reg_write(cam, REG_GPR, GPR_C1EN|GPR_C0EN); /* pwr up, reset */ - mdelay(1); /* Marvell says 1ms will do it */ +// mdelay(1); /* Marvell says 1ms will do it */ cafe_reg_write(cam, REG_GPR, GPR_C1EN|GPR_C0EN|GPR_C0); - mdelay(1); /* Enough? */ +// mdelay(1); /* Enough? */ spin_unlock_irqrestore(&cam->dev_lock, flags); } @@ -1796,18 +1802,19 @@ static void cafe_frame_tasklet(unsigned if (list_empty(&cam->sb_avail)) break; /* Leave it valid, hope for better later */ clear_bit(bufno, &cam->flags); - /* - * We could perhaps drop the spinlock during this - * big copy. Something to consider. - */ sbuf = list_entry(cam->sb_avail.next, struct cafe_sio_buffer, list); + /* + * Drop the lock during the big copy. This *should* be safe... + */ + spin_unlock_irqrestore(&cam->dev_lock, flags); memcpy(sbuf->buffer, cam->dma_bufs[bufno], cam->pix_format.sizeimage); sbuf->v4lbuf.bytesused = cam->pix_format.sizeimage; sbuf->v4lbuf.sequence = cam->buf_seq[bufno]; sbuf->v4lbuf.flags &= ~V4L2_BUF_FLAG_QUEUED; sbuf->v4lbuf.flags |= V4L2_BUF_FLAG_DONE; + spin_lock_irqsave(&cam->dev_lock, flags); list_move_tail(&sbuf->list, &cam->sb_full); } if (! list_empty(&cam->sb_full))