VIDIOC_SUBDEV_G_EDID, VIDIOC_SUBDEV_S_EDID — Get or set the EDID of a video receiver/transmitter
|struct v4l2_subdev_edid *argp|
|const struct v4l2_subdev_edid *argp|
File descriptor returned by
These ioctls can be used to get or set an EDID associated with an input pad from a receiver or an output pad of a transmitter subdevice.
To get the EDID data the application has to fill in the
fields and call
VIDIOC_SUBDEV_G_EDID. The current EDID from block
start_block and of size
will be placed in the memory
edid points to. The
pointer must point to memory at least
blocks * 128 bytes
large (the size of one block is 128 bytes).
If there are fewer blocks than specified, then the driver will set
to the actual number of blocks. If there are no EDID blocks available at all, then the error code
ENODATA is set.
If blocks have to be retrieved from the sink, then this call will block until they have been read.
To set the EDID blocks of a receiver the application has to fill in the
edid fields and set
start_block to 0. It is not possible to set part of an EDID,
it is always all or nothing. Setting the EDID data is only valid for receivers as it makes
no sense for a transmitter.
The driver assumes that the full EDID is passed in. If there are more EDID blocks than
the hardware can handle then the EDID is not written, but instead the error code E2BIG is set
blocks is set to the maximum that the hardware supports.
start_block is any
value other than 0 then the error code EINVAL is set.
To disable an EDID you set
blocks to 0. Depending on the
hardware this will drive the hotplug pin low and/or block the source from reading the EDID
data in some way. In any case, the end result is the same: the EDID is no longer available.
Table A.100. struct v4l2_subdev_edid
|__u32||Pad for which to get/set the EDID blocks.|
|__u32||Read the EDID from starting with this block. Must be 0 when setting the EDID.|
|__u32||The number of blocks to get or set. Must be less or equal to 256 (the
maximum number of blocks as defined by the standard). When you set the EDID and
|__u8 *||Pointer to memory that contains the EDID. The minimum size is
|__u32||Reserved for future extensions. Applications and drivers must set the array to zero.|
On success 0 is returned, on error -1 and the
errno variable is set appropriately. The generic error codes are described at the Generic Error Codes chapter.
The EDID data is not available.
The EDID data you provided is more than the hardware can handle.