[linux-dvb] Re: TechnoTrend DVB-T Card PCI Dump (unknown V.ID/Dev.ID)

[Oliver Endriss <o.endriss@gmx.de>]

Paolo Casagranda wrote:
> I've dumped the PCI settings with lspci -vxx and this is the section
> of interest when the Drivers are installed:
>
> 00:0b.0 Multimedia controller: Philips Semiconductors SAA7146 (rev
> 01) Subsystem: Unknown device a000:a000
> 	Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
> Stepping- SERR- FastB2B-
> 	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> 	Latency: 64 (3750ns min, 9500ns max)
> 	Interrupt: pin A routed to IRQ 5
> 	Region 0: Memory at dfffc600 (32-bit, non-prefetchable) [size=512]
> 00: 31 11 46 71 06 00 80 02 01 00 80 04 00 40 00 00
> 10: 00 c6 ff df 00 00 00 00 00 00 00 00 00 00 00 00
> 20: 00 00 00 00 00 00 00 00 00 00 00 00 00 a0 00 a0
                                          ^^^^^^^^^^^
> 30: 00 00 00 00 00 00 00 00 00 00 00 00 05 01 0f 26

Looks fine except vendor id/device id (marked ^^^^).
Do you get the same values immediately after reboot when the DVB driver 
has not been loaded yet? If yes, it's not a DVB driver problem.
A PCI driver expert should have a look at this.

Oliver


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.