[linux-dvb] Skystar2 rev2.6B working... almost

[Niklas Peinecke <peinecke@gdv.uni-hannover.de>]

Hi all,

I'm working on a driver for the new Technisat Skystar2 rev2.6B (also 
known as 2.68). It's got a different tuner than the old revision (a 
Samsung TBMU24112IMB1 with a STV0299 and a SL1935).
Basically I fixed a bug in skystar2.o concerning i2c-handling and put it 
together with the stv0299 driver and the sl1935 tuning routine from the 
mt312 driver, then I get a signal and a carrier from the card, but no 
viterbi (signal too low) and no sync.
I doubt that it's got something to do with the clock settings, but I 
haven't done any hardware programming since 1990.

Two guestions:
* Should I modify the master clock setting? M_CLK is 88 Mhz, but 
according to the specs I would rather say the stv0299 is set to 22 Mhz??
* What should the pll clock setting in the sl1935 tuning routine be? 
Currently I just left it at 10 Mhz, but I doubt it should be different.

It would be great if some frontend specialist could help me.

Thanks,

Niklas



--
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.