[linux-dvb] Re: Pinnacle Media Center 300i PCI Card

[Nico Sabbi <nsabbi@tiscali.it>]

Rainer Schubert wrote:

> Hi,
>
> in an earlier thread I read about that card after I had bought one, which
> works happily under WinXP, but delivers just a snowy image under Linux.
>
> I use the insmod option "card=26" as advised in that earlier thread and
> here are the messages I get using "dmesg" on an 2.6.8-10 kernel on a
> Debian Linux system.
>
> saa7134[0]: found at 0000:00:0c.0, rev: 1, irq: 209, latency: 32, mmio:
> 0xe0102000
> saa7134[0]: subsystem: 11bd:002d, board: Pinnacle PCTV Stereo (saa7134)
> [card=26,insmod option]
> saa7134[0]: board init: gpio is c806000
> saa7134[0]: i2c eeprom 00: bd 11 2d 00 f8 f8 1c 00 43 43 a9 1c 55 d2 b2 92
> saa7134[0]: i2c eeprom 10: 00 f0 04 04 ff 20 ff ff ff ff ff ff ff ff ff ff
> saa7134[0]: i2c eeprom 20: 01 40 01 02 03 ff 03 01 08 ff 00 25 ff ff ff ff
> saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
> tuner: chip found at addr 0xc0 i2c-bus saa7134[0]
> tuner: type set to 33 (MT20xx universal) by saa7134[0]
> tuner: microtune: companycode=3cbf part=42 rev=2f
> tuner: microtune MT2050 found, OK
> tda9885/6/7: chip found @ 0x86
> saa7134[0]: registered device video0 [v4l2]
> saa7134[0]: registered device vbi0
> saa7134[0]/irq[10,173361]: r=0x20 s=0x00 PE
> saa7134[0]/irq: looping -- clearing PE (parity error!) enable bit
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
> tuner: TV freq (0.00) out of range (44-958)
>
> Is there another insmod option to activate the Zarlink MT352 DVB-T
> demodulator that is on the board in difference to the Pinnacle PCTV Stereo
> (saa7134) board which lacks this chip ?
>
> Regards,
> Rainer
>  
I don't have this card, so I'm just guessing, but did you insmod 
saa7134_dvb
(or however else it's called)?