[linux-dvb] airstar2: no vhf in hannover

[Jan-Simon Möller <dl9pf@gmx.de>]

Hi folks!

I own a airstar 2 and I can't receive the vhf multiplex with my card.
After reading the old posts, I tried 2.6.10 with no success.

lspci -vv:
0000:01:0a.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB 
chip / Technisat SkyStar2 DVB card (rev 02)
        Subsystem: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / 
Technisat SkyStar2 DVB card
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 32
        Interrupt: pin A routed to IRQ 16
        Region 0: Memory at ec000000 (32-bit, non-prefetchable) [size=64K]
        Region 1: I/O ports at b400 [size=32]


dvb-t/de-Hannover
initial transponder 198500000 1 3 9 1 1 3 0
initial transponder 490000000 0 2 9 1 1 3 0
initial transponder 498000000 0 2 9 1 1 3 0
initial transponder 530000000 0 2 9 1 1 3 0
initial transponder 594000000 0 2 9 1 1 3 0
initial transponder 658000000 0 2 9 1 1 3 0

The 198500000 is missing.


>>> tune to: 
198500000:INVERSION_AUTO:BANDWIDTH_7_MHZ:FEC_3_4:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE
WARNING: >>> tuning failed!!!
>>> tune to: 
198500000:INVERSION_AUTO:BANDWIDTH_7_MHZ:FEC_3_4:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE 
(tuning failed)
WARNING: >>> tuning failed!!!
>>> tune to: 
490000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE



Thanks a lot!

Jan-Simon


Any sugestions ?