[mpeg2] Re: problem with setting module option and some audio error

["nimeesh" <nimeesh@divinetaccess.com>]

Hi Johann,

I applied the patch "2.4.23-3" and also passing option as card=23 buf still
i'm getting same error

What will be going wrong?

Thanks in Advance,
nimeesh


----- Original Message -----
From: "Johann Hanne" <jhml@gmx.net>
To: "nimeesh" <nimeesh@divinetaccess.com>; <mpeg2@linuxtv.org>
Sent: Wednesday, January 07, 2004 5:01 PM
Subject: [mpeg2] Re: problem with setting module option and some audio error


> Hi nimeesh,
>
> you should make sure that you use the latest patch from
> http://bytesex.org/patches/2.4.23-4/patch-2.4.23-kraxel.gz
> as this includes a patch to the card information which is required to get
> audio to work with the BMK MPEX card w/ tuner.
>
> The correct option is "card=23". I also get the "audio carrier scan
failed"
> message, but the default of 5.5 MHz works fine for me. After loading the
> driver you have to tune to a channel before using /dev/video{0,1},
otherwise
> you get invalid argument or input/output error. To do the tuning you might
> use the xawtv package. You can scan the channels with scantv (which is
only
> built if you install zvbi from http://zapping.sourceforge.net/ before
> compiling xawtv) and switch channels with fbtv (requires a working
> framebuffer setup) or xawtv/v4lctl (both requires X libs to compile which
is
> stupid for v4lctl, as this is a command line tool :-().
>
> After that you get a beautiful MPEG2 TS stream from /dev/video1. The
drivers
> are rock stable, I've been reading the stream and multicasting it for more
> than 4 weeks now without any problem.
>
> Cheers, Jonny
>
> On Tuesday 06 January 2004 13:58, nimeesh wrote:
> > Hi,
> >
> > I tried to use BMK MPEX board with Tunner on linux  with Kernel 2.4.23
and
> > module version of saa7134 is 0.2.9 .
> >
> > i'm able compile the module and it is getting installed but it is giving
> > error like
> > "saa7134[0]/audio: audio carrier scan failed. using 5.500 MHZ [default]"
> > what is means ??
> > is i'm missing out any thing??
> >
> > after this with video device file when i try to read data...
> > with no card option given and with card option=18,23 for module saa7134
> > "cat /dev/video0"  gives error as "invalid argument"
> > and with "cat /dev/video1" it gives  error as "Input/Output Error"
> >
> > with card option=22..
> > device video1 gives error as "no such device" while video0 is giving
same
> > error.
> >
> > how to configure input source like S-Video, Composite or Tunner???
> >
> > Thanks in advance,
> > nimeesh
>
>
>