[vdr] Re: Can't start transfer mode ?!

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Nils Heidorn wrote:
> 
> Hi !
> 
> This has probably been asked before, maybe you can provide a short hint, i
> searched the mailing list to no success ...
> 
> I just installed a Suse 7.3 Box with newest DVB driver ( snapshot from
> today ) and the 0.99pre1 VDR.
> 
> i can run vdr just fine, but when i switch to an encrypted channel i get the
> message in RED on the OSD: "Can't start transfer mode".
> 
> Any hints whats happening here ??
> 
> Thanks,
> 
> Nils

Did you adjust the 'Ca' Parameters to your setup?
The default is '3' (my system has 3 DVB cards...).
If you have _one_ card you have to enter '1' here.

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________