[vdr] Re: CA-Modul is not detectet by vdr-1.0.0 with AIO-Patch

[Stefan Lang <steven@organet.com>]

Holy sh...t, (sorry)

it _is_ Rev. 1.6! Didn't know anything about this problem!
Is there definitively no chance to get this thing working in the near future? 
Klaus???

Am Don, 2002-04-18 um 10.18 schrieb Andreas Grapp:
> Hi Stefan,
> 
> did you buy the new Hauppauge 3,5" Common Interface?
> Take up the case and take a look at the Rev.-Number on the Board.
> If it's Rev. 1.6 then the Interface is not supported by the driver/firmware
> (I had the same problem).
> The old ones (Rev. 1.4) work fine, but the new one (Rev. 1.6) does not work.
> With the original Hauppauge-Software everything is fine.
> 
> Andreas
> 
> ----- Original Message -----
> From: "Stefan Lang" <steven@organet.com>
> Newsgroups: boerde.lists.vdr
> Sent: Thursday, April 18, 2002 9:00 AM
> Subject: [vdr] CA-Modul is not detectet by vdr-1.0.0 with AIO-Patch
> 
> 
> > Hello List,
> >
> > last version I used was 0.98 with patch... no problems with the CAM!
> >
> > Now I have upgraded my hardware and also vdr to version 1.0.0 with
> > AIO-patch.
> >
> > After doing the obliged RTFM, I configured my system... free-to-air runs
> > fine, but PW with irdeto 4.7se ... no go...the screen stays black!
> > There is no message in /var/log/messages when I remove or insert the
> > CA-Modul... in 0.98 there came up a message in syslog!
> >
> > I'm using _one_ hauppauge dvb-s with CI-Card in 3,5"-Floppy-format
> > BTW What's about using the CI-card infrared-sensor with lirc??....
> > I know: slightly off topic
> >
> > Kernel is 2.4.18 witch ACL-Patches.
> >
> > Okay here is my config:
> >
SNIP