[vdr] Re: pvr and lirc...

["jpulz@frm2.tu-muenchen.de" <jpulz@frm2.tu-muenchen.de>]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Tue, 15 Oct 2002, Steffen Koch wrote:

> Schrevel, Milena wrote:
> > hi all,
> > i want to control my pvr with a remote control. i installed lirc and
> > libirman. i am using suse linux 8.0.
> > i installed vdr with "make remote=lirc". with the help of irrecord i created
> > a lircd.conf. my remote control now works only for a few keys (for changeing
> > the channels and volume) but i cannot go to the menue... is there something
> > like lircd.conf for pvr as well?
>
> Did you use the correct identifiers in the lircd.conf?
> vdr uses:
> up, down, menu, ok, back, left, right, red, green, yellow, blue, 0..9,
> power, volume+, volume-, mute

which card, and which remte control are you using??

i had a problem with the Hauppauge Nexus Rev.-2.1

irrecord saved the wrong values for me.. it saved only the KEY_UP events..
everytime i pressed a button, i got an KEY_DOWN and then
KEY_UP..KEY_UP..KEY_UP..KEY_UP..KEY_UP..KEY_UP..KEY_UP..KEY_UP..........
until i pressed a button again..

after i recognized that, i changed every value in the lircd.conf to the
right KEY_DOWN value and changed some of the paramters at the beginning of
lircd.conf..
now everything works good for me..

the irrecord value (KEY_UP) was for example:

Volume+	0x000000000000002c

the right value (KEY_DOWN) is for example:

Volume+ 0x000000080000002c

sorry, but i DON'T know if the 8 is at the right place.. i can't look on
my configuration yet.. so, please make sure that you use the right value
as seen on your screen!!!

joerg
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org

iD8DBQE9rAo/SPOsGF+KA+MRAk34AJ9WdQEpKXTXlWXTkEcwBSYrPcSN1gCeNvBz
HCEV2reX99eo7byv0H19ILM=
=YdzO
-----END PGP SIGNATURE-----




-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.