[vdr] SV: Re: SV: CAM support, was Improved CAM support in VDR

[Tomas Prybil <tomas.prybil@copper.se>]

Klaus,

I've tested the different cards in both slots and restarted the driver and
vdr... 

Is there any code that actually could verify that it sees any hw?

/t

-----Ursprungligt meddelande-----
Från: Klaus Schmidinger [mailto:Klaus.Schmidinger@cadsoft.de] 
Skickat: den 11 januari 2003 17:23
Till: vdr@linuxtv.org
Ämne: [vdr] Re: SV: CAM support, was Improved CAM support in VDR

Tomas Prybil wrote:
> 
> First of all Klaus thanks again for your tremendous effort regarding the
VDR
> software!!
> 
> My vdr installation has been sleeping for quite some time because of the
CAM
> problems. Here in Scandinavia almost all channels are encrypted and now I
> really look forward to use my vdr again!
> 
> However my installation doesn't really work.
> 
> Currently I have the following config:
> Kernel 2.4.10
> Technotrend DVB-S Rev 1.5
> CAM card "holder" Rev 1.6
> linux-dvb.2003-01-08-ci-ll driver
> vdr-1.1.21
> 
> The setup doesn't detect my CAM modules. I've tested both the Conax and
> Viacess but the only thing I get is the initial handshake --> 00 01 82 01
01
> but no response :( Normally they work in my Nokia box.
> 
> Any ideas?

Are you sure you have installed the CAM in the "0" slot?
Try both slots. Since there is no response to the [00 01 82 01 01] there
is nothing VDR can do. So I would assume that the CAM is in the wrong
slot.

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as
subject.


--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.