[vdr] vdr-1.2.26 does not know its recordings (BUG)

[Tobias Haustein <haustein@aixmail.de>]

Hi folks,

I've observed the following strange behaviour of vdr-1.2.26: 

After restarting vdr, it the timer.conf file and starts to record two
channels. However, in the menu, _no_ active recording is shown and 
therefore it is impossible to stop the recordings. The timer.conf
file in question is the following:

----
3:S19.2E-0-12188-12003:12:1206:1506:50:50:@Beverly Hills, 90210 Little Big Brother:
3:S19.2E-0-12188-12020:12:1208:1508:50:50:@The Naked Chef Folge 9:
----

It's not hand-crafted, but a regular timer.conf file that has been written
on exit of the same vdr just seconds before.

I don't know (yet) which conditions lead to the problem, but it seems to
happen in _most_ cases.

The second strange effect is that I can record the same channel multiple
times at once. If I keep pressing "menu"-"red", I can start lots of
concurrent recordings of the same channel. I just managed to start 8 such
recordings of RTL, but then after some seconds vdr crashed with a segfault.

Again, after restarting vdr, the 8 recordings did not show up in the menu,
but were continued as can be seen in the syslog.


Ciao,

Tobias

-- 
Tobias Haustein

E-Mail tobias.haustein@aixmail.de


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.