[vdr] Re: Matrix CAM and Conax

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Ora Järvinen wrote:
> 
> Klaus Schmidinger wrote:
> > Ora Järvinen wrote:
> >>
> >> I have a Matrix reloaded CAM since quite some time and it works
> >> nicely in my Topfield TF3000.
> >>
> >> Today I received the CI (floppy version) for my Technotrend 1.5 (VDR
> >> 1.2.6-18).
> >>
> >> I have an official TV Finland card (Conax).
> >>
> >> The card  & CAM work fine in the Topfield.
> >>
> >> I have only managed to get the combo running very randomly under VDR.
> >> Basically, it only very occasionally descrambles the channel
> >> (usually not, and if it does, it takes some time). When it does not,
> >> it also usually blacks out all other (FTA) channels. In this case, a
> >> CAM reset seems to be enough to make them visible again, but not to
> >> enable the csrambled channel.
> >>
> >> I can reliably start the CAM menu, and it also recognises the card
> >> (says Conax card inserted).
> >>
> >> There are occasional errors in syslog:
> >>
> >> Apr  6 16:54:53 vdr vdr[30056]: ERROR: CAM: Read failed: slot 0,
> >> tcid 1
> >> Apr  6 16:55:01 vdr vdr[30056]: CAM: MR 1.053, 01, 0100, CEEC
> >>
> >> What's going on?
> >
> > Which version of VDR are you using?
> 
> Says above - 1.2.6-18 :-)

Aaarghh - I did look twice and still missed it...
What exactly does the '-18' maen?

> > Have you tried with version 1.3.6?
> 
> No, not yet. If I have time, I might though. I'll let you know.

Ok.

Klaus


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.