[vdr] Converting a .dvrrc file to a channels.conf?

[Norm Dressler <norm@dressler.ca>]

Is there such a program to convert a dvrrc file to a channels.conf?

I'm making progress.  I downloaded the tuxzap software and was able to build 
the list of transponders for Nimiq 1, then using satscan I was able to obtain 
all of the channels.  

When I use tuxzap to tune to a channel, mplayer is only playing audio -- no 
video.  It says video not found.  

Playing -.
Reading from stdin...
Cache fill: 19.34% (1622016 bytes)    TS file format detected.
DEMUX OPEN, AUDIO_ID: -1, VIDEO_ID: -1, SUBTITLE_ID: -1,
PROBING UP TO 2000000, PROG: 0
NO VIDEO! AUDIO MP2(pid=5669) NO SUBS (yet)!  PROGRAM N. 0
Opened TS demuxer, audio: 50(pid 5669), video: ffffffff(pid -1)...POS=40796
==========================================================================
Trying to force audio codec driver family libmad...
Opening audio decoder: [libmad] libmad mpeg audio decoder
AUDIO: 48000 Hz, 1 ch, 16 bit (0x10), ratio: 20000->96000 (160.0 kbit)
Selected audio codec: [mad] afm:libmad (libMAD MPEG layer 1-2-3)
==========================================================================
Checking audio filter chain for 48000Hz/1ch/16bit -> 48000Hz/2ch/16bit...
AF_pre: af format: 2 bps, 1 ch, 48000 hz, little endian signed int
AF_pre: 48000Hz 1ch Signed 16-bit (Little-Endian)
AO: [oss] 48000Hz 2ch Signed 16-bit (Little-Endian) (2 bps)
Building audio filter chain for 48000Hz/1ch/16bit -> 48000Hz/2ch/16bit...
Video: no video


Any suggestions?