[linux-dvb] voltage control for DVB-T and DiSEqC switches

Felix Domke tmbinc at elitedvb.net
Sun Jul 24 23:05:13 CEST 2005


Johannes Stezenbach wrote:
> On Fri, Jul 22, 2005 Andreas Oberritter wrote:
>>I want to change frontend.h in a source and binary compatible way to
>>allow setting 5V (for active DVB-T antennas) and 12V (for DiSEqC
>>switches which don't need 13V or 18V to switch polarization).
> How is 12V different from 13V for DiSEqC switches?
The point was to drain as less power as possible. 13V is probably 14V
most of the time, so it should be a small (with 100mA, it would be
200mW. not really much, i agree, but one could use an unregulated 12V in
order to avoid the step-up-step-down process which is sometimes used to
generate the LNB voltage out of 12V) save.

But you're right, it's more a mental setting with the meaning of "stop
that legacy crap, use diseqc, only diseqc".

> I believe most frontends don't support a seperate 12V setting,
> or am I wrong?
Some popular satellite receiver supports every voltage from ~12V to ~20V
(iirc) as they use a PWM. :)


Felix




More information about the linux-dvb mailing list