[linux-dvb] Two card config question

Manu Abraham abraham.manu at gmail.com
Sun Oct 30 19:55:05 CET 2005


Philip Prindeville wrote:

> Manu Abraham wrote:
>
>> Philip Prindeville wrote:
>>
>>>
>>> Here's my logs, but as I said, I had to run the "modprobe bttv0" by 
>>> hand...
>>>
>>> Oct 29 18:17:47 tuner kernel: IrDA: Registered device irda0 (via-ircc)
>>> Oct 29 18:17:47 tuner kernel: Linux video capture interface: v1.00
>>> Oct 29 18:17:47 tuner kernel: cx2388x dvb driver version 0.0.4 loaded
>>> Oct 29 18:17:47 tuner kernel: cx88[0]: subsystem: 7063:3000, board: 
>>> pcHDTV HD3000 HDTV [card=22,autodetected]
>>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKB] 
>>> enabled at IRQ 12
>>> Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 12 as level-triggered
>>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.2[A] -> 
>>> Link [LNKB] -> GSI 12 (level, low) -> IRQ 12
>>> Oct 29 18:17:47 tuner kernel: cx88[0]/2: found at 0000:00:14.2, rev: 
>>> 5, irq: 12, latency: 32, mmio: 0xdf000000
>>> Oct 29 18:17:47 tuner kernel: cx88[0]/2: cx2388x based dvb card
>>
>>
>>
>>
>> You have the frontend for the cx88 ..
>>
>>> Oct 29 18:17:47 tuner kernel: DVB: registering new adapter (cx88[0]).
>>> Oct 29 18:17:47 tuner kernel: DVB: registering frontend 0 (pcHDTV 
>>> HD3000 HDTV)...
>>> Oct 29 18:17:47 tuner kernel: cx2388x v4l2 driver version 0.0.4 loaded
>>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.0[A] -> 
>>> Link [LNKB] -> GSI 12 (level, low) -> IRQ 12
>>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: found at 0000:00:14.0, rev: 
>>> 5, irq: 12, latency: 32, mmio: 0xde000000
>>> Oct 29 18:17:47 tuner kernel: tuner 0-0061: chip found @ 0xc2 (cx88[0])
>>> Oct 29 18:17:47 tuner kernel: tuner 0-0061: type set to 52 (Thomson 
>>> DDT 7610 (ATSC/NTSC))
>>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device video0 
>>> [v4l2]
>>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device vbi0
>>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device radio0
>>> Oct 29 18:17:47 tuner kernel: bttv: driver version 0.9.15 loaded
>>> Oct 29 18:17:47 tuner kernel: bttv: using 8 buffers with 2080k (520 
>>> pages) each for capture
>>> Oct 29 18:17:47 tuner kernel: bttv: Bt8xx card found (0).
>>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.0[A] -> 
>>> Link [LNKA] -> GSI 10 (level, low) -> IRQ 10
>>> Oct 29 18:17:47 tuner kernel: bttv0: Bt878 (rev 17) at 0000:00:13.0, 
>>> irq: 10, latency: 32, mmio: 0xe0001000
>>> Oct 29 18:17:47 tuner kernel: bttv0: detected: ChainTech digitop 
>>> DST-1000 DVB-S [card=113], PCI subsystem ID is 270f:fc00
>>> Oct 29 18:17:47 tuner kernel: bttv0: using: Twinhan DST + clones 
>>> [card=113,autodetected]
>>> Oct 29 18:17:47 tuner kernel: bttv0: using tuner=4
>>> Oct 29 18:17:47 tuner kernel: bttv0: add subdevice "dvb0"
>>> Oct 29 18:17:47 tuner kernel: bt878: no version for "struct_module" 
>>> found: kernel tainted.
>>> Oct 29 18:17:47 tuner kernel: bt878: AUDIO driver version 0.0.0 loaded
>>> Oct 29 18:17:47 tuner kernel: bt878: Bt878 AUDIO function found (0).
>>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.1[A] -> 
>>> Link [LNKA] -> GSI 10 (level, low) -> IRQ 10
>>> Oct 29 18:17:47 tuner kernel: bt878(0): Bt878 (rev 17) at 00:13.1, 
>>> irq: 10, latency: 32, memory: 0xe0002000
>>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKD] 
>>> enabled at IRQ 7
>>> Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 7 as level-triggered
>>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:10.3[D] -> 
>>> Link [LNKD] -> GSI 7 (level, low) -> IRQ 7
>>> ...
>>> Oct 29 19:20:29 tuner kernel: or51132: Waiting for firmware 
>>> upload(dvb-fe-or51132-vsb.fw)...
>>> Oct 29 19:20:39 tuner kernel: or51132: Version: 10001134-19430000 
>>> (113-4-194-3)
>>> Oct 29 19:20:39 tuner kernel: or51132: Firmware upload complete.
>>> Oct 29 19:21:17 tuner kernel: DVB: registering new adapter (bttv0).
>>> Oct 29 19:21:17 tuner kernel: dst_get_device_id: Recognise [DST-03T]
>>> Oct 29 19:21:17 tuner kernel: DST type : satellite
>>> Oct 29 19:21:17 tuner kernel: DST type flags : 0x2 ts204 0x4 symdiv 
>>> 0x10 firmware version = 2
>>> Oct 29 19:21:17 tuner kernel: DVB: registering frontend 1 (DST 
>>> DVB-S)...
>>>
>>
>> You have the dst too ..
>>
>>>
>>> Any more suggestions?
>>>
>>
>> Now what's the problem.. ?
>>
>> Manu
>>
>
> Well, it's not installing "dst" on reboot.  I have to do "modprobe 
> bttv0" and "modprobe bttv1"
> by hand...



I am not very clear on the install and --ignore-install-options. If you 
don't find any help on this, maybe you can try out on the Fedora lists.
https://www.redhat.com/archives/fedora-list/
https://www.redhat.com/archives/fedora-config-list/


If you find a solution, please do update the documentation on the wiki 
as well ..

Manu

Manu




More information about the linux-dvb mailing list