[linux-dvb] CableStar2 dont work (2.6.13 + dvb-kernel CVS)

[dvb]

CableStar2 Rev:1.2 (Flexcop IIB + STV02970 + TDEE4-017A) in Windows OK, in Linux dont work
--------
00:12.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 
DVB card (rev 02)
        Subsystem: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at ffae0000 (32-bit, non-prefetchable) [size=64K]
        Region 1: I/O ports at ef80 [size=32]
--------
Bus  0, device  18, function  0:
    Class 0280: PCI device 13d0:2103 (rev 2).
      IRQ 11.
      Master Capable.  Latency=64.
      Non-prefetchable 32 bit memory at 0xffae0000 [0xffaeffff].
      I/O at 0xef80 [0xef9f].
--------

Sep 10 12:18:12 sct kernel: b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded 
successfully
Sep 10 12:18:12 sct kernel: flexcop-pci: will use the HW PID filter.
Sep 10 12:18:12 sct kernel: flexcop-pci: card revision 2
Sep 10 12:18:12 sct kernel: DVB: registering new adapter (FlexCop Digital TV device).
Sep 10 12:18:12 sct kernel: b2c2-flexcop: MAC address = 00:d0:d7:28:1d:35
Sep 10 12:18:12 sct kernel: b2c2-flexcop: i2c master_xfer failed
Sep 10 12:18:12 sct last message repeated 2 times
Sep 10 12:18:12 sct kernel: mt352_read_register: readreg error (reg=127, ret==-121)
Sep 10 12:18:12 sct kernel: b2c2-flexcop: i2c master_xfer failed
Sep 10 12:18:12 sct kernel: i2c_readbytes: i2c read error (addr 0a, err == -121)
Sep 10 12:18:12 sct kernel: b2c2-flexcop: i2c master_xfer failed
Sep 10 12:18:12 sct kernel: b2c2-flexcop: i2c master_xfer failed
Sep 10 12:18:12 sct kernel: stv0297_readreg: readreg error (reg == 0x80, ret == -22)
Sep 10 12:18:12 sct kernel: b2c2-flexcop: i2c master_xfer failed
Sep 10 12:18:12 sct kernel: mt312_read: ret == -121
Sep 10 12:18:12 sct kernel: b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter