[linux-dvb] Compro DVB-T300 remote

Mark Callaghan mark at lostcow.com
Tue Apr 4 15:02:00 CEST 2006


I have done a mythdora install, with some problems with the remote on the Compro DVB-T300. The card is not registering as an input device, as it did with a previous install (earlier kernel, dvb module build from cvs). Relevant parts of dmesg (from a cold boot) below. Two items of interest:

    input: device saa7134 IR (Compro Videomate DV is statically allocated, will not register
    Please convert to input_allocate_device() or contact dtor_core at ameritech.net
    saa7134[0]: registered input device for IR

and

    tuner 2-0061: i2c i/o error: rc == -5 (should be 4)

I don't know if this "tuner 2..." line means anything or not.

Has there been some change in the kernel that saa7134 doesn't know about? Is there a possible build problem with mythdora?

Cheers,
Mark






dmesg:
 Linux version 2.6.15-1.1831_FC4 (bhcompile at tweety.build.redhat.com) (gcc version 4.0.2 20051125 (Red Hat 4.0.2-8)) #1 Tue Feb 7 13:37:42 EST 2006

snip

Linux video capture interface: v1.00
saa7130/34: v4l2 driver version 0.2.14 loaded
saa7130/34: snapshot date 2005-11-09
ACPI: PCI Interrupt Link [LNK2] enabled at IRQ 11
ACPI: PCI Interrupt 0000:02:09.0[A] -> Link [LNK2] -> GSI 11 (level, low) -> IRQ 11
saa7134[0]: found at 0000:02:09.0, rev: 1, irq: 11, latency: 32, mmio: 0xea000000
saa7134[0]: subsystem: 185b:c900, board: Compro Videomate DVB-T300 [card=70,insmod option]
saa7134[0]: board init: gpio is 843f00
input: device saa7134 IR (Compro Videomate DV is statically allocated, will not register
Please convert to input_allocate_device() or contact dtor_core at ameritech.net
saa7134[0]: registered input device for IR
saa7134[0]: i2c eeprom 00: 5b 18 00 c9 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7134[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 20: 01 40 01 03 03 ff 03 01 08 ff 00 87 ff ff ff ff
saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 40: ff 02 00 c2 86 10 ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff cb
saa7134[0]: i2c eeprom 60: 34 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
tuner 2-0061: chip found @ 0xc2 (saa7134[0])
tuner 2-0061: type set to 67 (Philips TD1316 Hybrid Tuner)
tuner 2-0061: type set to 67 (Philips TD1316 Hybrid Tuner)
tuner 2-0068: chip found @ 0xd0 (saa7134[0])
tda9887 2-0043: chip found @ 0x86 (saa7134[0])
saa7134[0]: registered device video0 [v4l2]
saa7134[0]: registered device vbi0
DVB: registering new adapter (saa7134[0]).
DVB: registering frontend 0 (Philips TDA10046H DVB-T)...

snip

tda1004x: setting up plls for 48MHz sampling clock
tda1004x: found firmware revision 23 -- ok
tuner 2-0061: i2c i/o error: rc == -5 (should be 4)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.linuxtv.org/pipermail/linux-dvb/attachments/20060404/cebfbf39/attachment.htm


More information about the linux-dvb mailing list