[linux-dvb] cam state is wrong after cam reset

christophpfister at bluemail.ch christophpfister at bluemail.ch
Thu Apr 13 14:11:13 CEST 2006


Hello

When I reset the cam (CA_RESET) and then immediately query its state (CA_GET_SLOT_INFO),
"flags" is set to 0 meaning no cam present.

But when I wait approximately 250ms after the reset and query the state,
everything is ok.

Is there any other solution to avoid this issue except waiting? I'm currently
writing software which depends on correct cam detection.

Thank you for any answers.

Christoph




More information about the linux-dvb mailing list