[linux-dvb] Can not compile the latest CVS code.
wweng at kencast.com
Wed Jan 18 17:54:51 CET 2006
I did a make reload and it did get rid of all the incompatible version
symbol error messages.
But this persists in the dmesg log:
bttv: driver version 0.9.16 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Host bridge needs ETBF enabled.
bttv: Bt8xx card found (0).
PCI: Found IRQ 3 for device 0000:00:0f.0
PCI: Sharing IRQ 3 with 0000:00:0f.1
bttv0: Bt878 (rev 17) at 0000:00:0f.0, irq: 3, latency: 132, mmio:
bttv0: detected: Twinhan VisionPlus DVB [card=113], PCI subsystem ID is
bttv0: using: Twinhan DST + clones [card=113,autodetected]
bttv0: enabling ETBF (430FX/VP3 compatibilty)
bttv0: gpio: en=00000000, out=00000000 in=00d500ff [init]
ir-kbd-i2c: i2c IR (Hauppauge) detected at i2c-1/1-001a/ir0 [bt878 #0 [hw]]
bttv0: using tuner=4
bttv0: add subdevice "dvb0"
bt878: AUDIO driver version 0.0.0 loaded
bt878: Bt878 AUDIO function found (0).
PCI: Found IRQ 3 for device 0000:00:0f.1
PCI: Sharing IRQ 3 with 0000:00:0f.0
bt878(0): Bt878 (rev 17) at 00:0f.1, irq: 3, latency: 64, memory: 0xf0002000
DVB: registering new adapter (bttv0).
dst_probe: unknown device.
frontend_init: Could not find a Twinhan DST.
dvb-bt8xx: A frontend driver was not found for device 109e/0878
Why is there still no front end?
Michael Krufky wrote:
> On 1/13/06, Daniel Sanjurjo <sanjurjo at myrealbox.com> wrote:
>> I had a similar problem. I think it's due to mixing modules from diferent
>> versions. I rmmod all the modules related with the card and tried to load
>> them again, and it worked.
> You're right.
> A quick way to rmmod all the modules and then insmod them all over
> again, from a recently build cvs, without even having to do make
> install, you can just do:
> make reload
> linux-dvb mailing list
> linux-dvb at linuxtv.org
More information about the linux-dvb