[linux-dvb] Another patch for hvr1110

Hartmut Hackmann hartmut.hackmann at t-online.de
Sun Oct 29 21:44:39 CET 2006


Hi, Tom

tomlohave at gmail.com wrote:
> Hartmut Hackmann a écrit :
> 
>> Hi. Tom
>>
>> <snip>
>>
>>>>
>>>> TNT ok
>>>> Analogic TV : OK
>>>> Capture device : not tested
>>>> Remote control : Nothing works (perhaps ...)
>>>> Radio : not tested
>>>
>>> Radio is Ok
>>>
>>> Bye, Bye
>>>
>>>>
>>>> Well, that's all for today !
>>>>
>>>>>> Good luck
>>>>>>   Hartmut
>>>>>>   
>>>>>
>>>>> Thanks :)
>>>>>
>>>>> Tom
>>>>>
>>>>>>
>>
>> So you have the board fully working now?
>> I am in doubt about this:
>>
>>>>> +    case SAA7134_BOARD_HAUPPAUGE_HVR1110:
>>>>> +        ir_codes     = ir_codes_hauppauge_new;
>>>>> +//        ir_type = IR_TYPE_RC5;
>>>>> +        mask_keycode = 0;
>>>>> +        polling         = 50; // ms
>>>>> +        break;
>>
>>
> No, there is no remote control.
> Nothing with regspy about gpio when i press a button under windows so 
> it's not for today.
> I search ...
> need test about input device too.
> So to summarize :
> 
> tv : ok
> tnt : ok
> radio : ok
> input device : not tested.
> remote control : nothing.
> 
> Even with  tv working, i have  the same logs about device not locked, so 
> is there something wrong ?
> Logs are here :
> 
> http://perso.wanadoo.fr/tomlohave/log-with-i2c_debug=1.log
> 
> Thanks.
> 
>> if mask_keycode applies to the complete GPIO port (not sure
>> in this case), this cannot be right since part of this
>> port is used for the DVB transport stream. Can you please
>> cross check this?
>> Also i must say that i lost sync. After you checked, can you
>> please resend your patch (maybe to me personally) so that i can
>> integrate it?
>>
>> Hartmut
>>
> Tom.
> 
The "not locked" messages are ok. Right after initialization, the
tner driver tunes to 400MHz, to get the tuner into a legal state.
If there is no signal, the tda8290 will report no lock.

Best regards
    Hartmut



More information about the linux-dvb mailing list