[linux-dvb] DVICO NANO Australia

Collier Family judithc at bigpond.net.au
Thu Nov 8 00:34:21 CET 2007


I have a  DVICO NANO but I am having the same troubles others had in June. It appears it is not being recognised as being cold. 

I have followed the instructions at http://fremnet.net/article/228/dvico-fusionhdtv-dual-digital-4-under-linux and all went well except the frontend not set. dmesg follows

usb 5-8: new high speed USB device using ehci_hcd and address 9
usb 5-8: configuration #1 chosen from 1 choice
dvb-usb: found a 'DViCO FusionHDTV DVB-T NANO2' in warm state.
dvb-usb: bulk message failed: -22 (2/0)
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (DViCO FusionHDTV DVB-T NANO2)
dvb-usb: bulk message failed: -110 (1/0)
dvb-usb: bulk message failed: -110 (3/0)
dvb-usb: bulk message failed: -110 (3/0)
dvb-usb: bulk message failed: -110 (5/0)
dvb-usb: no frontend was attached by 'DViCO FusionHDTV DVB-T NANO2'
dvb-usb: DViCO FusionHDTV DVB-T NANO2 successfully initialized and connected.

Is there any other information that may help I am running vanilla 2.6.23.1 kernel on Scientific linux 5.0

Thanks a lot for the work so far. 

Stephen Collier

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.linuxtv.org/pipermail/linux-dvb/attachments/20071108/598aeca1/attachment.htm 


More information about the linux-dvb mailing list