[linux-dvb] Technisat HD2 cannot szap/scan

[Pavel Hofman]

Michel Verbraak napsal(a):
>>   
> Pavel,
> 
> The reason why you probably do not get picture on LNB1 is because you 
> are still getting a stream from LNB0. Probably there is a transponder on 
> LNB0 with the same frequency and symbolrate as on LNB1 (frequency 11515 
> MHz H, symbolrate 27500000) but the specified PIDs (vpid 0x0947, apid 
> 0x0948) do not exist. Therefore you do not get a picture.
> 
> Have a look at http://nl.kingofsat.net/pos-19.2E.php. Find the 
> transponder for LNB0 with the same frequency and symbolrate (frequency 
> 11515 MHz H, symbolrate 27500000) as tried on LNB1 but with a set of 
> PIDs that exist on LNB0. Change the channels.conf file and szap again to 
> LNB1 with these parameters. If you do get picture you are sure that the 
> diseqc switch is not switching but stays on LNB0.
> 
> Please report your result to the list.
> 
> Regards,
> 
> Michel.

Hi Michel,

I appreciate your help a lot. Fortunately I can tune the second LNB now. 
  I got caught by the scan/mplayer LNB numbering inconsistency too.

Regards,

Pavel.