[linux-dvb] [PATCH 2/3] New card supported(partially): Pinnacle 800i

Chaogui Zhang czhang1974 at gmail.com
Sun Jan 13 19:34:29 CET 2008


On Jan 13, 2008 11:29 AM, Steven Toth <stoth at linuxtv.org> wrote:
> > TS is working, see the latest patches in my xc5000-analog tree.
> >
> > I'll look at these dumps now.
> >
>
> Zhang, these register values didn't help, which means that we're
> probably missing minor configuration parameters on the s5h1409 demod
> when running in parallel mode.
>
> That being said I switch the pinnacle 800i configuration in cx88 to
> switch to use serial mode, also patch a couple of registers, now it's
> streaming digital transport (QAM was tested) correctly. ATSC should also
> work just as well.

Hi, Steve,

I am on the road right now, so I could only do some limited testing with
command line tools.

With the latest change set 6957, seems like the TS at least now have
data output, but I am not sure if it is correct, since the PIDs (reported
by scan) are not right (compared to the PIDs reported on a working card
at the same frequency). In fact, the PIDs seem like just random numbers.

Or do you have a more recent patch?

>
> Please confirm this is true.
>
> Also, I added support for IR but this remains completely untested. If
> someone can plug in an IR receiver and press a few buttons then the
> driver should be processing them correctly - much like we do for the
> Hauppauge HVR3000 products (IE. It's a native feature of the cx2388x
> silicon).

I don't see any IR related code in the change set 6957. Did you push
these patch to the hg tree yet? In any case, I will do more test later
tonight when I get back home (for both TS and IR).

-- 
Chaogui Zhang



More information about the linux-dvb mailing list