I've got a Dposh DVB-T USB2.0 (marked ATMT) and I've downloaded some firmware ( which was v.difficult to find as the page in the wiki is blank) which put the stick into a "warm" state i.e.<br><br>dvb-usb: found a 'Dposh DVB-T USB2.0' in cold state, will try to load a firmware<br>
dvb-usb: downloading firmware from file 'dvb-usb-dposh-01.fw'<br>dvb_usb_m920x: probe of 5-1:1.0 failed with error 64<br>dvb-usb: found a 'Dposh DVB-T USB2.0' in warm state.<br>dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.<br>
dvb-usb: Dposh DVB-T USB2.0 successfully initialized and connected.<br>usbcore: registered new interface driver dvb_usb_m920x<br><br>I've tried Kaffeine and w_scan to no avail, (WinXP gets a signal), I could do with some advice on a)perhaps new firmware and b)help with how to use dvbsnoop or similar to divine what is happening with this device as I lack sufficient knowledge to proceed<br>
Regards Andrew<br><br>