[vdr] nvram-wakeup problems

Simon Baxter linuxtv at nzbaxters.com
Fri Jun 10 20:25:36 CEST 2005


Thanks.

I changed the values in the BIOS, which seemed to work for that error.

Now I get :

WakeUp Second value (63) not correct

But there's no "second value" in the BIOS??
----- Original Message ----- 
From: "Sergei Haller" <Sergei.Haller at math.uni-giessen.de>
To: "Klaus Schmidinger's VDR" <vdr at linuxtv.org>
Sent: Friday, June 10, 2005 4:24 PM
Subject: Re: [vdr] nvram-wakeup problems


> On Fri, 10 Jun 2005, Simon Baxter (SB) wrote:
>
> SB> nvram-wakeup: value of the addr_stat    byte is: 0x9F.
> SB> nvram-wakeup: value of the addr_day     byte is: 0xFF.
> SB> nvram-wakeup: value of the addr_hour    byte is: 0xFF.
> SB> nvram-wakeup: value of the addr_min     byte is: 0xFF.
> SB> nvram-wakeup: value of the addr_sec     byte is: 0xFF.
> SB> nvram-wakeup: value of the addr_chk_h   byte is: 0x1A.
> SB> nvram-wakeup: value of the addr_chk_l   byte is: 0x74.
> SB> nvram-wakeup: Checksum is: 0x1A74.
> SB> nvram-wakeup: WakeUp Hour value (31) not correct.
>
>
> Please go into your BIOS Setup, enable the wakeup and _change_ every value
> (day, hour, minute, second) of the wakeup time.
>
> Then try running nvram-wakeup again.
>
> On some boards this procedure will "initialize" the stored values to
> values which make sense.
>
>
>        Sergei
> -- 
> --------------------------------------------------------------------  -?)
>         eMail:       Sergei.Haller at math.uni-giessen.de               /\\
> -------------------------------------------------------------------- _\_V
> Be careful of reading health books, you might die of a misprint.
>                -- Mark Twain
>
> _______________________________________________
> vdr mailing list
> vdr at linuxtv.org
> http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.323 / Virus Database: 267.6.6 - Release Date: 08/06/2005
>
> 




More information about the vdr mailing list