[vdr] The corect way to stop VDR

Paul Lacatus paul.lacatus at gmail.com
Mon Jan 2 20:32:37 CET 2006


On 1/2/06, Oliver Endriss <o.endriss at gmx.de> wrote:
>
> Paul Lacatus wrote:
> > I am using vdr 1.3.37 on full featured thechnisat Rev 1.3 card. Drivers
> are
> > from kernel 2.6.14.  I have another digital receiver connected on the
> loop
> > output of the ss1 board. After closing  vdr by ctrl-c in console  the
> ss1
> > in not powering anymore the LNB  leaving the other receiver to do that
> but
> > is not allowing the high frequency  signal to pass trough (I presume )
> since
> > the other receiver is indicating bad signal. If I restart the computer
> all
> > is ok until I start again vdr.  I don't know if the problem is from vdr
> or
> > drivers.
>
> Load the dvb-core module with parameter 'dvb_shutdown_timeout=0'.



Thanks Oliver but i gave up of connecting another receiver on loop since I
need to leave my vdr powered up when using the other receiver.   I am using
now a very simple relay switch .

Regards
Paul

--
> --------------------------------------------------------
> VDR Remote Plugin available at
> http://www.escape-edv.de/endriss/vdr/
> --------------------------------------------------------
>
> _______________________________________________
> vdr mailing list
> vdr at linuxtv.org
> http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.linuxtv.org/pipermail/vdr/attachments/20060102/31567538/attachment.htm


More information about the vdr mailing list