[vdr] VDR doesn't always switch channel correctly

Thiemo rollercoaster at reel-multimedia.com
Fri Nov 9 11:07:23 CET 2007


Am Donnerstag 08 November 2007 schrieb Maxime Laplante:
> Hi guys,
>
> I'm running VDR 1.4.0 on my CaptiveWorks CW-3000HD FTA receiver.
>
> My current diseqc.conf is:
>
> # DiseqC Configuration
>
> # Port 0 Galaxy 11 & Nimiq 1,3
> S91.0W 99999 V 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
> S91.0W 99999 H 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
> S91.0W 99999 R 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
> S91.0W 99999 L 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20

I dont see how switching the polarisation is done - as toneburst, voltage and 
diseqc commands are all the same for each polarisation.
Also a repeated command should start with "E1" because "E0" would be for the 
next (cascaded) switch which is most probably not what was intended...
You could also repeat the commands twice, which is the default.
A correct diseqc block with 2 repeats should look like this:

S19.2E  11700 V   9750 t v W15 [E0 10 38 F0] W15 [E1 10 38 F0] W15 [E1 10 38 
F0] W15  t
S19.2E  99999 V  10600 t v W15 [E0 10 38 F1] W15 [E1 10 38 F1] W15 [E1 10 38 
F1] W15  T
S19.2E  11700 H   9750 t V W15 [E0 10 38 F2] W15 [E1 10 38 F2] W15 [E1 10 38 
F2] W15  t
S19.2E  99999 H  10600 t V W15 [E0 10 38 F3] W15 [E1 10 38 F3] W15 [E1 10 38 
F3] W15  T

regards, 
T.



More information about the vdr mailing list