[vdr] VDR doesn't always switch channel correctly

Timothy D. Lenz tlenz at vorgon.com
Fri Nov 9 22:58:13 CET 2007


He has a Dish Pro LNB. The switching is done via the two LO settings. He
wants V high always for propper operration of the LNB. They like the voltage
to be at 18-19v

Try increasing the delay a tad. change the W15's to W20 and the first W20's
to W25's. The W20's at the end I don't think are needed.

----- Original Message ----- 
From: "Thiemo" <rollercoaster at reel-multimedia.com>
To: "VDR Mailing List" <vdr at linuxtv.org>
Sent: Friday, November 09, 2007 3:07 AM
Subject: Re: [vdr] VDR doesn't always switch channel correctly


> Am Donnerstag 08 November 2007 schrieb Maxime Laplante:
> > Hi guys,
> >
> > I'm running VDR 1.4.0 on my CaptiveWorks CW-3000HD FTA receiver.
> >
> > My current diseqc.conf is:
> >
> > # DiseqC Configuration
> >
> > # Port 0 Galaxy 11 & Nimiq 1,3
> > S91.0W 99999 V 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
> > S91.0W 99999 H 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
> > S91.0W 99999 R 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
> > S91.0W 99999 L 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
>
> I dont see how switching the polarisation is done - as toneburst, voltage
and
> diseqc commands are all the same for each polarisation.
> Also a repeated command should start with "E1" because "E0" would be for
the
> next (cascaded) switch which is most probably not what was intended...
> You could also repeat the commands twice, which is the default.
> A correct diseqc block with 2 repeats should look like this:
>
> S19.2E  11700 V   9750 t v W15 [E0 10 38 F0] W15 [E1 10 38 F0] W15 [E1 10
38
> F0] W15  t
> S19.2E  99999 V  10600 t v W15 [E0 10 38 F1] W15 [E1 10 38 F1] W15 [E1 10
38
> F1] W15  T
> S19.2E  11700 H   9750 t V W15 [E0 10 38 F2] W15 [E1 10 38 F2] W15 [E1 10
38
> F2] W15  t
> S19.2E  99999 H  10600 t V W15 [E0 10 38 F3] W15 [E1 10 38 F3] W15 [E1 10
38
> F3] W15  T
>
> regards,
> T.
>
> _______________________________________________
> vdr mailing list
> vdr at linuxtv.org
> http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr




More information about the vdr mailing list