[vdr] Betr: Re: xineliboutput reports "no signal" when started on a paused playback

Gerald Dachs vdr at dachsweb.de
Sun Dec 9 11:56:46 CET 2012


Am 09.12.2012 10:14, schrieb cedric.dewijs at telfort.nl:
> I agree this behavior is normal and technically correct. I think its a bit
> confusing, because when I see no signal, i think there's something wrong
> with the receiving hardware, like crashed DVB-t receivers, loose antenna
> and so on.
>
> Xineliboutput is aware the stream is paused. Therefore I can think of 2 solutions:
> 1)Display a screen that says "Paused" instead of "No signal"
And how shall xineliboutput notice the difference?
> 2)Unpause, and then re-pause the stream, just long enough to let VDR send
> an image.
>
Xineliboutput didn't pause the stream, so it is not the job of 
xineliboutput to "unpause" the stream.

Gerald

!DSPAM:50c46e6f187481547110970!




More information about the vdr mailing list