[vdr] no image with TeVii S464

VDR User user.vdr at gmail.com
Sun Oct 27 17:22:15 CET 2013


If you always have a good signal with your Nexus then the problem is
not the lnb or cable. BTW, unfortunately the signal meter is
unreliable for a lot of cards because they don't follow a standardized
metric. It works for some cards, for others it's basically useless.

Other things to consider...  Is the driver for your TeVii S464 known
to be good/solid/stable? If not, the driver might be to blame. Is your
card correctly detected by the driver or do you have to manually tell
it which card you're using? Is the tuner on the card overheating? If
the copper core wire was cut too short, it can cause inconsistent
signal with some connectors, or no signal at all even if it works fine
with a different connector.

Basically there is not enough information to know the source of your
issue. You've got to do further investigation.

On Sun, Oct 27, 2013 at 8:12 AM, Sergio Daniel Gomez
<sergiogomez at tostado.com.ar> wrote:
> El 27/10/13 11:11, Peter Münster escribió:
>
>> Hi,
>>
>> This is probably not a VDR problem, but I guess that here are people who
>> could help perhaps.
>>
>> I use the femon plugin to check the signal, and there is only some 20%
>> of the first line (red), when I test my brand new TeVii S464, and no
>> image.
>>
>> When I replace the card with my old
>> "Technotrend/Hauppauge WinTV Nexus-S rev2.X", I get green signals and an
>> image, so it seems that everything is fine with my dish.
>>
>> Is there some configuration issue, or is this new card just broken?
>> Or do I need another LNB?
>>
>> TIA for any hints,
>>
>
> Hi.
> 20% it's poor signal. To check lnb you can put your hand between dish and
> lnb, signal must to change. If not, the problem it's with lnb.
> Regards.
>
>
> _______________________________________________
> vdr mailing list
> vdr at linuxtv.org
> http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr



More information about the vdr mailing list