TechniSat SkyStar HD: Difference between revisions

From LinuxTVWiki
Jump to navigation Jump to search
m (CI info)
(modules to load)
Line 25: Line 25:
Interrupt: pin A routed to IRQ 10
Interrupt: pin A routed to IRQ 10
Region 0: Memory at e9cffc00 (32-bit, non-prefetchable)[size=512]
Region 0: Memory at e9cffc00 (32-bit, non-prefetchable)[size=512]

=== modules ===

You need to
modprobe stb6100 stb0899 saa7146 lnbp21
modprobe budget-ci

If you don't load the other modules first, you'll get
DVB: Unable to find symbol stb6100_attach()
As with all DVB drivers, if you don't see any cards and frontends in multiproto's menuconfig, enable I2C in your kernel config and in multiproto do make distclean afterwards.


===Components Used===
===Components Used===

Revision as of 21:26, 14 November 2007

A DVB-S2 PCI card by TechniSat.

Experimental support exists.

Overview

Apparently the card is actually a rebranded TechnoTrend TT-budget S2-3200.

02:06.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
        Subsystem: Technotrend Systemtechnik GmbH Unknown device 1019
        Flags: bus master, medium devsel, latency 32, IRQ 20
        Memory at feaffc00 (32-bit, non-prefetchable) [size=512]
# lspci -v -n -s 02:06.0
02:06.0 0480: 1131:7146 (rev 01)
        Subsystem: 13c2:1019
        Flags: bus master, medium devsel, latency 32, IRQ 20
        Memory at feaffc00 (32-bit, non-prefetchable) [size=512]

output from lspci -vvv

01:00.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
        Subsystem: Technotrend Systemtechnik GmbH Unknown device 1019
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-<TAbort- <MAbort- >SERR- <PERR-
        Latency: 32 (3750ns min, 9500ns max)
        Interrupt: pin A routed to IRQ 10
        Region 0: Memory at e9cffc00 (32-bit, non-prefetchable)[size=512]

modules

You need to

modprobe stb6100 stb0899 saa7146 lnbp21
modprobe budget-ci

If you don't load the other modules first, you'll get

DVB: Unable to find symbol stb6100_attach()

As with all DVB drivers, if you don't see any cards and frontends in multiproto's menuconfig, enable I2C in your kernel config and in multiproto do make distclean afterwards.

Components Used

It also supports an add-on CI slot.

External Links