WinTV Model 44914 Rev C121
An analog PCI card from Hauppauge.
Radio In, TV In, Line Out, Composite In, Line In, IR In.
Everything is working "out of the box" except bundled remote control.
It may be necessary to load bttv module with parameter automute=0 if audio is unwantedly muting.
Remote is fully supported by lirc. With v4l-dvb drivers some known changes would need to be done to get the remote working.
Following modification was not accepted by maintainer (change was requested) but it may be applied to source code and recompiled to get this remote to a working state with v4l-dvb drivers.
Sample dmesg output
bttv: driver version 0.9.18 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 18, latency: 32, mmio: 0xdfdfe000 bttv0: detected: Hauppauge WinTV [card=10], PCI subsystem ID is 0070:13eb bttv0: using: Hauppauge (bt878) [card=10,autodetected] IRQ 18/bttv0: IRQF_DISABLED is not guaranteed on shared IRQs bttv0: gpio: en=00000000, out=00000000 in=00ffffdb [init] bttv0: Hauppauge/Voodoo msp34xx: reset line init  tveeprom 1-0050: Hauppauge model 44914, rev C121, serial# 3959906 tveeprom 1-0050: tuner model is Philips FM1216 (idx 21, type 5) tveeprom 1-0050: TV standards PAL(B/G) (eeprom 0x04) tveeprom 1-0050: audio processor is None (idx 0) tveeprom 1-0050: has radio bttv0: Hauppauge eeprom indicates model#44914 bttv0: tuner type=5 bttv0: audio absent, no audio device found! tuner 1-0061: chip found @ 0xc2 (bt878 #0 [sw]) tuner-simple 1-0061: creating new instance tuner-simple 1-0061: type set to 5 (Philips PAL_BG (FI1216 and compatibles)) bttv0: registered device video0 bttv0: registered device vbi0 bttv0: registered device radio0 bttv0: PLL: 28636363 => 35468950 . ok