[linux-dvb] Re: Switching

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Rainer Zocholl wrote:
> 
> I'm running two DVBs on one wire. (No Multiswitch possible.)
> 
> The default setup is "ntv" as we all know.
> and n-tv is "V", meaning 13V.
> 
> So that should not give any problem,
> and works flawlessly (with the known restrictions)
> but:
> 
> I see the following effect:
> 
> Switching from ARD(h) to Bloomberg(v)
> Bloomberg runs for serveral(!) minutes.
> Suddenly it stopps:
> 
> The second card -not used card- is suddenly giving 18V...
> (If i turn "record" on, bloomberg is back again, because
> the second card is tuned back to low voltage too)
> 
> Why?
> 
> The second card should be at 13V or not?

After some time the second card starts to scan the various transponders
to collect EPG data. You can disable this in the Setup by setting the
EPGScanTimeout to 0.

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.