[linux-dvb] Re: second DVB-s not used anymore

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Benjamin Harling wrote:
> 
> hi,
> 
> lately I installed vdr.0.9.5 with driver from 20010923.
> 
> Before I had vdr.0.9.4 with driver 20010822.
> 
> Equipment is a 350 MHz K6-II with one Hauppauge DVB-S and one NOVA-Card.
> Everything worked well up until I installed 0.9.5 with driver 20010923. From
> then on the NOVA-Card was still recognized but not used anymore. No more
> timeshift (which worked pretty good before) and other usefull stuff.
> 
> I backed up to the previous configuration to no avail.
> 
> Do you have any idea what might have went wrong?
> 
> SYSLOG transcript follows:
> 
> -----------------------------------------------------------
> 
> Sep 24 21:19:37 amun syslogd 1.3-3: restart.
> Sep 24 21:19:38 amun sshd[385]: RSA key generation complete.
> Sep 24 21:19:39 amun usbmgr[415]: start 0.4.1
> Sep 24 21:19:39 amun modprobe: modprobe: Can't locate module mousedev
> Sep 24 21:19:39 amun usbmgr[417]: "hid" was loaded
> Sep 24 21:19:39 amun usbmgr[417]: "mousedev" was loaded
> Sep 24 21:19:39 amun modprobe: modprobe: Can't locate module usb-uhci
> Sep 24 21:19:39 amun usbmgr[417]: "usb-uhci" was loaded
> Sep 24 21:19:39 amun usbmgr[422]: mount /proc/bus/usb
> Sep 24 21:19:39 amun usbmgr[417]: bye!
> Sep 24 21:19:40 amun modprobe: modprobe: Can't locate module net-pf-5
> Sep 24 21:19:40 amun last message repeated 3 times
> Sep 24 21:19:40 amun modprobe: modprobe: Can't locate module net-pf-5
> Sep 24 21:19:40 amun modprobe: modprobe: Can't locate module net-pf-5
> Sep 24 21:19:40 amun timelord[466]: main: atp_open: Address family not
> supported by protocol
>  24 21:19:40 amun kernel: klogd 1.3-3, log source = /proc/kmsg started.
> Sep 24 21:19:40 amun kernel: Inspecting /boot/System.map-2.4.6
> Sep 24 21:19:41 amun kernel: Loaded 15971 symbols from
> /boot/System.map-2.4.6.
> Sep 24 21:19:41 amun kernel: eth0: DC21140 at 0xe800 (PCI bus 0, device 18),
> h/w address 00:c0:f0:40
> :2c:01,
> Sep 24 21:19:41 amun kernel:       and requires IRQ5 (provided by PCI BIOS).
> Sep 24 21:19:41 amun kernel: de4x5.c:V0.546 2001/02/22
> davies@maniac.ultranet.com
> Sep 24 21:19:41 amun kernel: eth0: media is 100Mb/s full duplex.
> Sep 24 21:19:42 amun /usr/sbin/cron[533]: (CRON) STARTUP (fork ok)
> Sep 24 21:20:10 amun login: FAILED LOGIN 1 FROM /dev/tty1 FOR root,
> Authentication failure
> Sep 24 21:21:37 amun su: (to root) root on /dev/tty1
> Sep 24 21:21:37 amun PAM-unix2[630]: session started for user root, service
> su
> Sep 24 21:21:37 amun vdr[631]: VDR version 0.94 started
> Sep 24 21:21:37 amun vdr[631]: loading /video0/setup.conf
> Sep 24 21:21:37 amun vdr[631]: loading /video0/channels.conf
> Sep 24 21:21:37 amun vdr[631]: loading /video0/timers.conf
> Sep 24 21:21:37 amun vdr[631]: loading /video0/commands.conf
> Sep 24 21:21:37 amun vdr[631]: probing /dev/ost/qpskfe0
> Sep 24 21:21:37 amun vdr[633]: EIT processing thread started (pid=633) -
> master
> Sep 24 21:21:37 amun vdr[631]: probing /dev/ost/qpskfe1
> Sep 24 21:21:37 amun vdr[631]: ERROR (dvbapi.c,3003): Bad file descriptor
> Sep 24 21:21:37 amun vdr[634]: EIT processing thread started (pid=634)
> Sep 24 21:21:38 amun vdr[631]: probing /dev/ost/qpskfe2
> Sep 24 21:21:38 amun vdr[631]: probing /dev/ost/qamfe2
> Sep 24 21:21:38 amun vdr[631]: found 2 video devices
> Sep 24 21:21:38 amun vdr[631]: invalid DVB interface: 0

For some reason your "primary interface" setting appears to have been broken.
Please check the line

   PrimaryDVB = X

in your 'setup.conf'. If X is not '1' or '2', then please delete that line
and try running VDR again.

> Sep 24 21:21:38 amun vdr[631]: switching to channel 24
> Sep 24 21:21:38 amun lircd-0.6.4[303]: accepted new client on /dev/lircd
> Sep 24 21:21:38 amun vdr[635]: LIRC remote control thread started (pid=635)
> Sep 24 21:21:38 amun vdr[631]: SVDRP listening on port 2001
> Sep 24 21:21:38 amun vdr[631]: setting watchdog timer to 60 seconds
> Sep 24 21:21:45 amun vdr[631]: timer 10 start
> Sep 24 21:21:45 amun vdr[631]: switching to channel 24
> Sep 24 21:21:45 amun vdr[631]: Title: 'Der große Stromausfall - Eine Stadt
> im Ausnahmezustand' Subti
> tle: '(null)'
> Sep 24 21:21:45 amun vdr[631]: record
> /video0/Der_große_Stromausfall_-_Eine_Stadt_im_Ausnahmezustand
> /2001-09-24.20:13.50.50.rec
> Sep 24 21:21:46 amun vdr[631]: SpinUpDisk took 0.70 seconds
> Sep 24 21:21:46 amun vdr[631]: recording to
> '/video0/Der_große_Stromausfall_-_Eine_Stadt_im_Ausnahme
> zustand/2001-09-24.20:13.50.50.rec/004.vdr'
> Sep 24 21:21:46 amun vdr[641]: output thread started (pid=641)
> Sep 24 21:21:46 amun vdr[642]: input thread started (pid=642)
> Sep 24 21:21:46 amun kernel: VFS: Disk change detected on device ide1(22,64)
> Sep 24 21:21:46 amun vdr[631]: max. latency time 1 seconds
> Sep 24 21:21:49 amun vdr[631]: info: Kanal blockiert (zeichnet auf)!
> Sep 24 21:21:51 amun vdr[631]: max. latency time 2 seconds
> Sep 24 21:21:52 amun kernel: VFS: Disk change detected on device ide1(22,64)
> 
> -----------------------------------------------------------
> 
> As you can see on the last but third line the channel is blocked alltough
> there are two dvb-devices ("found 2 video devices").

You might also want to try the latest CVS driver version together with VDR version 0.96.

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________


--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.