[linux-dvb] Re: Problems with 1.1.1

["Andreas Share" <a.share@t-online.de>]

>
> > Be careful. The new code _works_ with BSRU6 (stv0299) and the old BSRV2
> > module. Remember that DiSEqC is _always_ done by the av7110 on
> > full-featured cards.
>
> That is very weird.. So the new-ves1x93 must be in some mode that is
> interfering with the DISEQC being sent by the av7110... I can't think of
any
> other explanation.


Hi,

this could not be caused by the latest changes, because 1.1.0 doesnīt work
also.

But between 1.0.1 and 1.1.0 was some init changed in ves1x93 related to the
polarisation. Maybe somone can test it with the old value...

static
u8 init_1893_tab [] = {
        0x01, 0xA4, 0x35, 0x81, 0x2A, 0x0d, 0x55, 0xC4,
        0x09, 0x69, 0x00, 0x86, 0x4c, 0x28, 0x7F, 0x00,
        0x00, 0x81, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00,
-        0x80, 0x00, 0x31, 0xb0, 0x14, 0x00, 0xDC, 0x00,
+        0x80, 0x00, 0x31, 0xb0, 0x14, 0x00, 0xDC, 0x20,
        0x81, 0x80, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00,
        0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00,
        0x00, 0x55, 0x00, 0x00, 0x7f, 0x00
};

This bit set the initial voltage to 0V (before 13V)...

By the way....the hole before_after_tune/notifier stuff doesenīt work as
aspected...sometimes the driver run into the wrong funktion, because he
reported HAS_LOCK, but i was at the beginning of tunig, sometimes
av7110_before_after_tune() reported lock and set up the pids, but tuning
isenīt finished.

Greetings



-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.