[linux-dvb] Re: Getting the Pinnacle PCTV SAT CI to work

[Flea <flea@evocars.net>]

On Fri, 2004-05-07 at 01:40, Maarten van Ingen wrote:
> Hi,
> 
> I'm trying to get my pctv sat ci to work on my linux pc. But so far 
> nothing but troubles.
> I'm using gentoo with the 2.6.5 kernel.
> The drivers seems to be loaded correctly (as module and in-kernel).
> Here a part of dmesg:
> 
> bttv0: Bt878 (rev 17) at 0000:00:0f.0, irq: 5, latency: 32, mmio: 0xd7000000
> bttv0: detected: Pinnacle PCTV SAT CI [card=113], PCI subsystem ID is 
> 11bd:0026
> bttv0: using: Twinhan DST + clones [card=113,autodetected]
> bttv0: gpio: en=00000000, out=00000000 in=00f500fd [init]
> bttv0: using tuner=4
> bttv0: add subdevice "dvb0"
> 
> But the problem i have is that there isn't a device video0, wich is 
> needed to work.
> Even when i enable all dvb devices in the kernel i still won't get a 
> video0 in my /dev/dvb/adapter0
> I get the following devices: demux0, dvr0, frontend0, net0.
> 
> I really don't know where to go. Can anybody help me out with this?
> 
> Maarten van Ingen
> 

> 
Does PCTV CI have an onboard mpeg decoder?
I think you get /dev/video0 only if you have mpeg +
v4l drivers loaded.

While tuning on a channel with szap -r , try running

cat /dev/dvb/adapter0/dvr0 | mplayer -

(mplayer reading raw ts)

hope that's help, and if you get your CICAM to work, please
let me know...
guido





-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.