[vdr] Re: VDR developer version 1.1.9

[Meinrad Sauter <meinrad.sauter@gmx.de>]

Am Sonntag 08 September 2002 18:43 schriebst Du:
>Am Sonntag 08 September 2002 18:27 schriebst Du:
>>Meinrad Sauter wrote:
>>> Hi Klaus, hi all,
>>>
>>> great feature, and it works...
>>> ...at least for a few seconds. Then I get
>>> GPIO0 irq oops
>>> ...
>>> many of them and then:
>>> dvb0: arm crashed
>>>
>>> This happens both when trying to timeshift and switching channels when a
>>> recording is running.
>>>
>>> Any Idea?
>>> BTW: Tried the CVS driver with FW from NEWSTRUCT as well as your patched
>>> one. DVB is a TT v1.5
>>
>>For a while I ran my VDR box with kernel 2.4.18 because of problems with
>>my MPEG encoder card. However, with that kernel apparently my harddisk
>>didn't work with DMA, so the performance was pretty bad. During that time
>>I also saw lots of "GPIO0 irq oops". Now I'm back to kernel 2.4.10 and it
>>works fine again.
>
>Thanks, thats a possibility. 2.4.18 is exactly the kernel I'm using. Will
> try a different Version and see if it helps.
>

I tried 2.4.10-xfs instead, but the problem remains. After a while I get the 
irq oops's even in live viewing mode without any recordings.
Am I the only one with this problem?


>>I did see an ARM crash, though, today when I ran a recording and tried to
>>switch to a channel that was currently not available because the tranponder
>>was locked due to the recording. Haven't further inverstigated that yet...
>>
>>Klaus

-- 
Meinrad Sauter
email: meinrad.sauter@gmx.de