[vdr] Re: Hauppauge Nexus 2.1 IR receiver connections

["sschmidt" <sschmidt@physik.hu-berlin.de>]

*********** REPLY SEPARATOR  ***********

On 26.09.02 at 20:26 Richard Scobie wrote:

>I am about to build the serial port IR receiver, as detailed at
>http://www.lirc.org/receivers.html, as I wish to use a non RC5 remote
>control with VDR.
>
>Rather than buy a receiver IC, I am assuming the receiver supplied with
>the Nexus card can be used and wondered if anyone knows the signals on
>the 3.5mm plug?
>
>Richard

Ok, a little bit difficult because i have glued all together with melting glue (Schmelzklebstoff) but i try.

|_____ ____ _
|_____ ____ _O
|  \         \       \
    \         \    Vcc
     \      Out
 Ground

I hope you understand my schematic. If you are unsure there is already a pullup resistor between Vcc and Out in the Chip. I think it is a SFH5110 or comparable.

Good luck




--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.