[vdr] Re: VDR developer version 1.1.23

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Johannes Lautner wrote:
> 
> Hi,
> 
> here are my test results for vdr 1.1.23 with ci.c of 03-02-2003 (plain VDR
> no Plugins)
> and dvb-2003-02-02-ci-ll
> 
> Setup:
> P5A with K6@350
> Siemens DVB-S 1.3 as primary
> Siemens DVB-S 1.3 with CI (PCI-Type) as secondary
> 
> Irdeto Allcam 4.7 SE
> Alphacrypt 1.0
> 
> Kernel SUSE 2.4.10
> 
> everything works nearly perfect, for a few seconds up to 1-2 minutes
> - VDR starts and finds my CAM
> - Debug-Output logs the Dialog between VDR and CAM
> - Decrypting works
> - after a unspecific time the CAM stops answering. Picture on a PW
>   channel freezes FTA works (picture on secondary card freezes also)
> - restarting VDR (without rmmod / insmod the driver) give me a new try,
>   with the same result (Both CAMs same error)

Since these two CAMs work fine in other systems I would assume some
other problem with your setup. Did either of these CAMs work with the old
driver (where CAM support was built into the firmware)?
Could this be a heat problem?

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.