[vdr] Re: probs with dxr3 install

[Simeon Walker <simeon@sbs.bangor.ac.uk>]

I think the problem is that you haven't got the right modules loaded
that are required by the em8300 modules.

If you install the modules into the correct place and then run depmod
you can then use modprobe to load the modules correctly.

Sim

On 03/05/03 13:11, Bläser, Lars wrote:

> i used the 0.13.0 driver with suse 8.1
> did configure, make, make install and in modules i start the ldm
> this gives a error:
> em8300.o unresolved symbol unregister_sound_dsp
> em8300.o unresolved symbol register_sound_dsp
>
> looked in archive and find:
> "Rebuilt using the headers from your current kernel or enable sound
> support in the kernel (or load the soundcore module)"
>
> i don´t think there is somthing wrong with the suse kernel and the on board soundsystem is detected and active
>
> after that i tried to start the em8300 dvb driver part (make, make insmod in em8300), the insmod gives a huge amount of errors, so i think the problem above should has to be solved before
>
> any hints?
>
>
>
>  
--
Simeon Walker,                      email: simeon@sbs.bangor.ac.uk
School of Biological Sciences,      phone: +44 (0)1248 383702
University of Wales, Bangor,        fax: +44 (0)1248 382569
Gwynedd, LL57 2UW, UK.              www: http://biology.bangor.ac.uk/




--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.