[vdr] Problems recording if bad signal

[Martin Neuditschko <yosuke.tomoe@gmx.net>]

Hello!

I am using DVB-c with QAM-256 with a very bad signal.
Often not the whole time is recorded. Today only the
first few minutes are recorded - I think until the
"ERROR: error in data stream!" lines in the log below.
Is it possible to do an emergency exit to force the
reload of the driver in this case?


vdr[6217]: VDR version 1.2.1 started
vdr[6217]: loading /video/setup.conf
vdr[6217]: ERROR: unknown config parameter: defaultCA = 0
vdr[6217]: ERROR: unknown config parameter: updateServices = 3
vdr[6217]: loading /video/sources.conf
vdr[6217]: loading /video/channels.conf
vdr[6217]: loading /video/timers.conf
vdr[6217]: loading /video/svdrphosts.conf
vdr[6217]: loading /video/remote.conf
vdr[6217]: probing /dev/dvb/adapter0/frontend0
vdr[6220]: EIT processing thread started (pid=6220) - master
vdr[6221]: tuner thread started on device 1 (pid=6221)
vdr[6217]: probing /dev/dvb/adapter1/frontend0
vdr[6217]: found 1 video device
vdr[6217]: setting primary device to 1
vdr[6217]: SVDRP listening on port 2001
vdr[6222]: KBD remote control thread started (pid=6222)
vdr[6217]: remote control KBD - keys known
vdr[6217]: switching to channel 4
vdr[6217]: reading EPG data from /video/epg.data
vdr[6217]: setting watchdog timer to 60 seconds
vdr[6223]: transfer thread started (pid=6223)
vdr[6224]: receiver thread started on device 1 (pid=6224)
vdr[6217]: timer 1 (4 1330-1600 'YBCO') start
vdr[6217]: waiting for EPG info...
kernel: ves1820.c: AFC (5) -33691Hz
vdr[6217]: no EPG info available
vdr[6217]: record /video/YBCO/_/2003-06-17.13:30.99.99.rec
vdr[6217]: recording to '/video/YBCO/_/2003-06-17.13:30.99.99.rec/002.vdr'
vdr[6226]: recording thread started (pid=6226)
vdr[6217]: max. latency time 4 seconds
vdr[6226]: ERROR: error in data stream!
vdr[6223]: ERROR: error in data stream!
vdr[6226]: recording thread ended (pid=6226)
vdr[6217]: cTS2PES got 6436 TS errors, 1468 TS continuity errors
vdr[6217]: cTS2PES got 462 TS errors, 324 TS continuity errors
vdr[6217]: buffer stats: 25628 (0%) used
vdr[6217]: timer 1 (4 1330-1600 'YBCO') stop

best regards
Martin Neuditschko


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.