[linux-dvb] Pinnacle sat and typhoon pci tv tuner

Nando Romano darkside_moon83 at yahoo.it
Mon Sep 12 16:47:50 CEST 2005


Is it possible that I have those problems 

(when I load the bttv module 
# modprobe bttv
my system don't see the pinnacle sat as a dvb-s card
as you can see it doesn't create dvb device

bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for
bttv: Bt8xx card found (0).
ACPI: PCI interrupt 0000:02:07.0[A] -> GSI 19 (level,
low) -> IRQ 177
bttv0: Bt878 (rev 17) at 0000:02:07.0, irq: 177,
latency: 64, mmio: 0xf7c00000
bttv0: detected: Pinnacle PCTV Sat [card=94], PCI
subsystem ID is 11bd:001c
bttv0: using: Pinnacle PCTV Sat [card=94,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=001f00fc
i2c-algo-bit.o: (0) scl=1, sda=1
i2c-algo-bit.o: (1) scl=1, sda=0
i2c-algo-bit.o: (2) scl=1, sda=1
i2c-algo-bit.o: (3) scl=0, sda=1
i2c-algo-bit.o: (4) scl=1, sda=1
i2c-algo-bit.o: bt878 #0 [sw] passed test.
bttv0: using tuner=-1
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 . ok

with my dvb-s pinnacle card because on my system there
is also another pci tv card (typhoon pci tv tuner
chipset philips saa7134)?

Perhaps my pinnacle sat card conflicts with  typhoon
pci tv tuner.
Is it possiblie?

I use my card if I load the saa7134 module
# modprobe saa7134  card=2 tuner=11

Do anyone have two tv cards on the same computer? are
they working correctly?

Can I use both the pctv cards?

Do I have to remove the saa7134 card  from the pci
if I want to use the pinnacle sat card?

Or it's only necessary not load the module (saa7134)
for the typhoon card ?

Or these two cards cannot conflict because the
chipsets and modules are different?

what do you think?

thank for all suggestion



Yahoo! Mail: gratis 1GB per i messaggi e allegati da 10MB 

More information about the linux-dvb mailing list