[linux-dvb] Airstar-HD5000-PCI LGDT330X frontend WORKS!

Jan Kansky jan at kansky.net
Thu Sep 22 04:44:05 CEST 2005

I wanted to report that I have version 3.1 of the TechniSat 
AirStar-HD5000-PCI working!

My base distribution is FC3.  I downloaded kernel from 
kernel.org, patched with the hd5000.patch and did make oldconfig based 
on the redhat fc3 .config.  Everything complied and installed fine.

The patch complained a bit, but the complaints were of no consequence. 
The one hunk that failed was a change made in a comment block so it 
didn't matter.  Here is the output:

[root at localhost src]# patch -p0 < hd5000.patch
patching file linux/drivers/media/dvb/b2c2/flexcop-fe-tuner.c
Hunk #1 succeeded at 13 with fuzz 2.
Hunk #2 succeeded at 299 (offset 1 line).
Hunk #3 succeeded at 416 (offset -44 lines).
patching file linux/drivers/media/dvb/b2c2/flexcop-misc.c
patching file linux/drivers/media/dvb/b2c2/flexcop-reg.h
patching file linux/drivers/media/dvb/b2c2/flexcop.c
patching file linux/drivers/media/dvb/frontends/dvb-pll.c
patching file linux/drivers/media/dvb/frontends/dvb-pll.h
patching file linux/drivers/media/dvb/frontends/lgdt330x.c
Hunk #1 FAILED at 27.
1 out of 2 hunks FAILED -- saving rejects to file 

lgdt330x.c.rej contains:
*** 27,32 ****
    *   DViCO FusionHDTV 3 Gold-T
    *   DViCO FusionHDTV 5 Gold
    *   DViCO FusionHDTV 5 Lite
    * TODO:
    * signal strength always returns 0.
--- 27,33 ----
    *   DViCO FusionHDTV 3 Gold-T
    *   DViCO FusionHDTV 5 Gold
    *   DViCO FusionHDTV 5 Lite
+  *   Air2PC HD5000
    * TODO:
    * signal strength always returns 0.

At this stage, I followed the instructions in:

(Except for the step about nxt-2002 firmware.  That is not needed)

Thanks to the developers!

More information about the linux-dvb mailing list