[linux-dvb] [TUA6030] Infineon TUA6030 driver available... =)
tanguy.pruvot at gmail.com
Fri Dec 5 01:56:15 CET 2008
Le mercredi 3 décembre 2008 à 00:15:27, vous écriviez :
> These tuners have been seen at first on Hauppauge products as
> replacement for the Philips FM1216ME/I H-3 (MK-3) and a member of the
> video4linux-list in the UK had confirmation from Hauppauge's user
> support there, that they are compatible with the prior tuner=38.
> This was for a MFPE05-2. (PE = PAL/Europe)
> I think a MFPE05-3-E was reported on some device too.
> Since then this tuner is mapped to tuner=38 in media/video/tveeprom.c
> and is on several Hauppauge devices, but also on others. No complaints
> so far.
> The layout of the tuner PCB of your MFPE05-2-E and the FM1216ME MK3
> seems to be identical. The most visible difference is, that the on your
> tuner just unused tuner pins 7 and 8 are not present at the Philips at
> all. Means 12 against 14 visible tuner pins according to your
> Else only the color of some of the coils differs and instead of TUA 6032
> marked on the pll chip, on the pll used by Philips is only printed B2
> and 230, but both have 38pins connected to the obviously same layout.
> You might even have the same original EPCOS SAW filters, but your tuner
> will not support NTSC, needs different filter equipment.
> NTSC is covered by the MFNM05. (NM = NTSC N/M)
> This also causes the different bandswitch takeover frequencies.
> On a first look at the main programming table all write and read bytes
> are identical up to every single bit. You can find the datasheet of the
> Philips FM1216ME MK3 we have these days at ivtvdriver.org.
> If we find details not covered by tuner=38, you can get a new tuner
> entry, but the patch must be against recent v4l-dvb. The radio should be
> treated like on the other MK3 tuners in tuner-simple.c I guess.
> IIRC, we have reports for radio working well with port1=1, inactive, FM
> high sensitivity.
> We would need a valid signed-off-by line from you as well.
> Thanks, especially for the picture of the opened tuner. We did not have
> any further details previously. Just testing results and the Hauppauge
Thanks for your help for tuners, i removed NTSC settings...
The default Philips settings doesn't work well, even it's working...
i updated tuner config to best values for TV by disabling AGC,
set to external AGC (0x60) in Init Auxiliary Byte
More information about the linux-dvb