[vdr] Problem: Conax not available after VDR startup

Klaus Schmidinger Klaus.Schmidinger at cadsoft.de
Sun Aug 7 16:10:45 CEST 2005

Rantanen Teemu wrote:
> I have a problem with my VDR setup. VDR does not see my Conax cam after
> a (VDR) restart. It is not possible to watch encrypted channels after
> the restart (channel not available), and VDR does not continue timer on
> an encrypted channel.
> VDR does detect Conax after some time, and then the timer continues to
> record and it is possible to switch to an encrypted channel on a live
> view, but the time before this happens can be annoyingly long. It is
> possible to make VDR detect Conax (almost) immediately if I initiate an
> EPG scan after the startup.
> I'd like to know if this happens to someone else too, and is there a
> workaround (or fix) to make VDR probe CI/cams immediately at startup.
> My Technotrend DVB-C is not a primary card (as I use xine -device),
> could this have something to do with the problem?

Strange. My two CAMs (both connected to my third DVB card) are detected
some 15..20 seconds after VDR is started - long before the EPG scan kicks in.


More information about the vdr mailing list