[vdr] Re: Re: [Announce] LNB-sharing patch for VDR 1.3.22

Markus Ehrnsperger Markus_Ehrnsperger at yahoo.de
Mon Mar 7 23:01:16 CET 2005

Matthias Lötzke says...
> All cards sharing the same LNB send DiSEqC signals one after another.
> If you switch the channel manually the primary card sends their DiSEqC
> signal allways as the last card.

Hi Matthias,

so if I switch from 

S19.2E  99999 H 10600       t V W15 [E0 10 38 F3] W15 T


S13E    99999 V 10600        t v W15 [E0 10 38 F5] W15 B W15 T

than the second DVB card will switch the tone off (while the first one is 
still sending the tone), the second DVB card will have low voltage (while the 
first one has still high voltage), than the second DVB card will send some 
DiSEqC sequences (disturbed by the tone of the first one) and will switch the 
tone on again. Than the first DVB card will send signals, again disturbed by 
the tone of the second DVB card.

Would it be possible to change this and make sure no DVB card sends the tone 
as long as DiSEqC sequences are sent? Or have you already built in this and I 
just missunderstood your mail?


More information about the vdr mailing list