Artec T1 USB TV Box
The device is based upon the DiBcom DVB-T USB 1.1 reference design.
- Dibcom DiB3000
Making it work
You will need either dvb-usb-dibusb-18.104.22.168.fw or dvb-usb-dibusb-an2235-01.fw in /lib/firmware or the relevant place for your distribution.
Just use the in-kernel drivers, or compile your own by following the How_to_install_DVB_device_drivers instructions.
You may need to make sure that the "Support faulty USB IDs" option is enabled.
<M> Multimedia devices <M> DVB/ATSC adapters <M> DiBcom USB DVB-T devices (based on the DiB3000M-B) [Y] Support faulty USB IDs
dvb_pll dib3000mb dvb_usb_dibusb_mb dvb_usb_dibusb_common dib3000mc dibx000_common dvb_usb dvb_core
Sample kernel output
usb 2-1: new full speed USB device using ohci_hcd and address 9 usb 2-1: configuration #1 chosen from 1 choice dvb-usb: found a 'Artec T1 USB1.1 TVBOX with AN2235 (faulty USB IDs)' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-dibusb-an2235-01.fw' usb 2-1: USB disconnect, address 9 dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. usb 2-1: new full speed USB device using ohci_hcd and address 10 usb 2-1: configuration #1 chosen from 1 choice dvb-usb: found a 'Artec T1 USB1.1 TVBOX with AN2135' in warm state. dvb-usb: will use the device's hardware PID filter (table count: 16). DVB: registering new adapter (Artec T1 USB1.1 TVBOX with AN2135) DVB: registering frontend 0 (DiBcom 3000M-B DVB-T)... dibusb: This device has the Thomson Cable onboard. Which is default. input: IR-receiver inside an USB DVB receiver as /class/input/input9 dvb-usb: schedule remote query interval to 150 msecs. dvb-usb: Artec T1 USB1.1 TVBOX with AN2135 successfully initialized and connected.
Remote control support
The IR receiver is presented as a normal input device.