Difference between revisions of "Audio Decoders"

From LinuxTVWiki
Jump to navigation Jump to search
Line 1: Line 1:
== TV Sound Standards ==
== TV Sound Standards ==
{| border=1 cellspacing=0 cellpadding=5
{| border=1 cellspacing=0 cellpadding=5
| Sound Carrier
| Sound Carrier
| Sound Modulation
| Sound Modulation

Revision as of 14:11, 29 January 2006

TV Sound Standards

TV-System Sound Carrier Sound Modulation Color System Country
B/G 5.5/5.7421875

TV Sound Decoding

The TV sound needs to be decoded in order to receive an Audio Frequency (Sound_AF) signal.

Historically this feature has been built into the tuner tin can, but this was only feasible for single TV sound standards. No programming was needed to get sound from the tuner.

As an alternative tuners always had an extra output Sound_IF (Intermediate Frequency), which can be used by sound decoder chips to extract stereo or implement support for multiple sound standards.

For stereo sound (and later Digital sound standards like NICAM) an external chips (e.g. msp3415 or other) was introduced and needs to be properly supported by the linux driver.

For BTSC stereo also some discrete module (e.g. NE41S) exists on various cards.

The next step was the integration of the sound decoder into the PCI chip (e.g. cx25840 and others).

Sound Routing

Another common problem are the multiple sound sources (e.g. Line In, Tuner Sound_AF, Sound-Decoder_AF) which have to be connected to the PCI interface chip. As this chip only had one sound input, an external switch (crossbar) is required, this is commonly a HEF4052 mux (but sound decoders can have also a crossbar).

Sound Output

Historically most TV cards had a Line Out for the TV sound. This can be connected directly to speakers/headphones of to Line In of the sound card.

Some cards had amplifiers in order to drive speakers or headphones directly. Else you need active speakers (which do the amplification themselves).

Newer PCI bridge chips can optionally digitize Sound_AF and deliver this over the PCI bus. You can direct this digital sound to the sound card.

In order for this to work the card IHV needs to connect the chips properly.