- Microtune MT2060 tuner
- Dibcom DiB7700 DVB-T demodulator & USB 2.0 controller
- IR receiver (not currently supported)
|USB ID||Model no.||Version||Tuner||Supported from|
- One model number is above the MAC address on the label on the underside of the device.
- The other model number and the version information are on the base of the box, below the bar code.
Making it work
You will need the dvb-usb-dib0700-03-pre1.fw firmware file in /lib/firmware or the relevant place for your distribution.
Status on 11 August 2007
Just use Mercurial by following the How_to_install_DVB_device_drivers instructions.
Sample kernel output
This is for the 70001 version, using the driver in Linux 18.104.22.168.
usb 1-10: new high speed USB device using ehci_hcd and address 8 usb 1-10: configuration #1 chosen from 1 choice dvb-usb: found a 'Hauppauge Nova-T Stick' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-dib0700-01.fw' dib0700: firmware started successfully. dvb-usb: found a 'Hauppauge Nova-T Stick' in warm state. dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. DVB: registering new adapter (Hauppauge Nova-T Stick). DVB: registering frontend 2 (DiBcom 7000MA/MB/PA/PB/MC)... MT2060: successfully identified (IF1 = 1220) dvb-usb: Hauppauge Nova-T Stick successfully initialized and connected.
Remote control support
At least the 70001 version has an IR sensor. Though as of 11 August 2007 there is no support for the sensor in v4l-dvb, it is known to work with Hauppauge's 45-button remote control and will handle signals from similar remote controls.
This patch implements support for the IR sensor; if you have problems with a flood of "unknown key" messages in the kernel log, you'll also need this patch (it is not cleanly applicable to recent trees, but it is an easy one-liner to do by hand).